Sekonic L-758 Instrukcja Obsługi Pobierz pdf (Strona 40)

-34-

NOTE:

5. Measurement

Reference:

•

Refer to the radio Receiver or Transceiver instruction manual for the recommended operating

method.

•

Maximum distance of the wireless flash radio triggering system can vary depending on the

placement of the remote Receiver or Transceiver, direction of the radios antenna, distance

from a large body of water or concrete wall and other possible factors.

1. Confirm the range between the meter (transmitter) and Receiver or Transceiver.

2. Place the meter and Receiver or Transceiver away from large metal objects, concrete,

objects, large moisture content (both people and trees fall into the category) and so

forth.

3. Secure the radio Receiver or Transceiver in place by using Velcro tape or a 1/4-20

mounting screw. Be sure that the entire length of the Receiver or Transmitter antenna

is higher than the flash pack. Avoid contact between the Receiver or Transceiver

antenna and metal objects at all times.

4. Depending on the location, there may be cases when the Receiver or Transceiver is

incapable of receiving any radio signals whatsoever. There are several possible causes

for this such as radio signals reflected off of nearby objects. This can generally be

resolved by shifting the meter (Transmitter) or the Receiver or Transceiver slightly in

one direction or another. In addition, confirm that the Receiver or Transceiver is not

placed behind objects that readily absorb or deflect radio signals such concrete, metal,

low hills, etc.

・Be sure to picture either RT-32CTL or RT-32N / RT32-FCC / RT-32CE according to your

receiver’s/transceiver’s type.

RT-32CE/FCC and RT-32N can trigger them.

(★1)If these ControlTL receivers/transceivers are set in Standard channel mode.

as well as the differences between Standard and ControlTL systems.

* Pleas visit pocketwizard.com to learn more about PocketWizard ControlTL radios

Compatible

NOT Compatible

FlexTT5, PowerST4 and PowerMC2

PLUS series and MultiMAX

For Standard channel triggering

For Standard channel triggering ONLY

RT-32FCC

RT-32CE

RT-32N

RT-32CTL (NEW)

For both Standard and ControlTL

channel triggering

For both Standard and ControlTL

channel triggering

•

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 67 68

Komentarze do niniejszej Instrukcji

Brak uwag

Sekonic L-758 Instrukcja Obsługi Strona 40

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola Sekonic L-758